How to install the Brother printer's tablet holder
Before using your mobile device / tablet holder
- The holder for mobile devices/tablets is designed to be used with Brother label printers TD-4420DN/TD-4520DN/TD-4550DNWB.
- It provides users with a fixed and comfortable viewing angle for their mobile device/tablet.
- This product is compatible with mobile devices/tablets between 4" and 9.7" - If your device is larger than 8", we recommend you place it in landscape mode.
- Make sure the support is securely fixed by tightening the nut at its back before sitting any device on it.
- Carefully position your device to maximise stability.
- Ensure that the protective cover of your tablet is not too large for the support guides.
Please, make sure not to open the top cover of the printer while the device is in place - Opening the printer to replace the label roll while your device is in place may cause damage to the tablet and/or the printer.
Main features
Features | Specs |
Product dimensions (including box) | 180mm x 140mm x 80mm |
Product size (without box) | 140mm x 120mm x 70mm |
Product weight (with box) | 234g |
Product weight (without box) | 113g (without mobile device) |
Storage environment | -20°C ~ 60°C 20%~80% HR |
Operating temperature | 0°C ~ 40°C 5%~90% HR |
Material Type | High Impact Polystyrene (HIPS) |
Material Properties | High impact resistance and stability. Complies with UL 94 flammability regulations. The material can be recycled. |
Impact Resistance | 1m drop test, 6 sides, 2 edges, 1 corner |
Device Protection | Protected by rubber pads |
Tightening Torque | 8~11Kgf/cm |
Compatibility | |
Mobile device size | Compatible with 4" to 9,.7" devices |
Scratch resistance | Integrated soft rubber pads protect the device from scratches |
Mobile Device weight (maximum) | 600gr |
Viewing Angle (maximum) | 30 ºC |
Deviation during use | A force of 500g causes a deviation of 10mm |
Compliance | Delegated directive (EU) 2015/863 Restriction of hazardous substances (RoHS) |
Installation Instructions
1. Insert each bushing (A) 
into each of the holes on the top cover of the equipment.
into each of the holes on the top cover of the equipment.
If these are already integrated into the equipment, begin installation at Step 2.2. Remove the double-sided adhesive tape from under the support before placing it on the printer.
3. Align the screw holes of the support with the plugs inserted into the printer, placing the washers (F) 
in front and behind the screw holes.
in front and behind the screw holes. Do not overtighten the screws (E). 
Components
Quantity in box
Components
Quantity in box
2
1
B 
1
E
2
C 
1
4
A |  D |
F |